Euchner EKS FSA with Profibus-DP Interface Instrukcja Użytkownika Pobierz pdf (Strona 25)

Manual EKS Electronic-Key Adapter Profibus-DP

7 Setup

During setup proceed as follows:

Check mounting and electrical connection are correct

(see section

5 Mounting and section 6 Electrical connection).

Set device address on the DIP switches on the Electronic-Key adapter

(see section

4.4 DIP switch settings).

Switch on power supply.

After the power supply is switched on, the LED on the front of the Electronic-Key adapter illuminates red. This

indicates that the supply voltage is present, but there is not yet any communication with the bus master. The

LED only changes from red to green following successful configuration.

Insert Electronic-Key in the Electronic-Key adapter.

During communication with the bus master and transfer of the data, the LED changes to yellow.

092009-03-10/07 Subject to technical modifications Page 25/36

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Brak uwag

Euchner EKS FSA with Profibus-DP Interface Instrukcja Użytkownika Strona 25